byko-drive S
BYK-Gardner
10
285 025 845 E 2106
4 System Operation
4.1 Start Up
Plug the external power supply into the connector on the rear of the instru-
ment near the power switch. Plug the other end into an appropriate electrical
outlet as described in section
.
Turn on the power switch. The power switch is located on the rear of the in-
strument, near the power cord.
The display will turn on and if not already there, the carriage will move to the
start point; the instrument is now ready to operate.
4.2 User Interface
All user functions are operated through a touchscreen interface.
4.2.1 Home Screen
The large
Play
button in the center starts the carriage moving with the speed,
travel and offset options as indicated on the display. The settings may be
changed by pressing the
Setup
icon in the upper right corner.
The six
Presets
buttons allow saving of six different setup combinations. The
settings are first changed within the
Setup
screen and then saved by pressing
and holding the
Presets
button where you would like to store the settings.
There are six setups stored from the factory, press each of the buttons to re-
view the settings before changing them.
