47
Difference measurement and Pass/Fail
11.5 Change standard
You can use this function to change target values
and limit values of saved standards. You can also
use it to define limit values subsequently (for
example for a measured standard). Use the scroll
wheel to move the mark to Change standard and
press the wheel.
All standards are listed one after the other in the
following menu. Select the desired standard and
press the scroll wheel.
In the next step you can define the target and limit
values as described above.
11.6 Delete standard
Use the selection wheel to move the mark to Delete
standard in the Difference menu and then press the
wheel.
The Delete standard menu appears. All saved
standards are listed in this menu.
If there are more standards than can be shown in
the display, arrows on the right edge of the display
will point to additional standards.
Use the scroll wheel to move the mark to the
desired standard and press the wheel.
The standard to be deleted is listed again in the
display. Confirm by pressing the mode scroll wheel.
The unit then reverts to the previous menu.
Change standard
STANDARD 1
STANDARD 2
STANDARD 3
STANDARD 4
STANDARD 7
STANDARD 5
Delete standard
STANDARD 1
STANDARD 2
STANDARD 3
STANDARD 4
STANDARD 7
STANDARD 5
Delete standard
STANDARD 5
Confirm --> [mode]
Cancel --> [operate]
