BYK-Gardner GmbH
Introduction | 1
301 200 141 E 2010
wave-scan 3 ROBOTIC
7
Only devices that meet the requirements for low-voltage safety may be
connected to the control interface (green).
For operation with the external power supply, care should be taken to en-
sure the nominal voltage of the power supply unit (see the manufacturer’s
plate on the power supply unit) matches the voltage supplied by the power
outlet.
The measurement device may be disconnected from the power supply as
follows:
By disconnecting the power plug (black) from the device.
You will find the technical data on the manufacturer’s plate and in the sec-
tion “Technical Data”.
Defects and extraordinary loads
If safe operation can no longer be presumed, shut down the device and se-
cure it against unintended operation.
The device must be presumed unsafe to operate:
• if visible damage is evident,
• if the instrument is no longer working,
• if it has been stored for long periods under adverse conditions,
• after harsh treatment during shipping.
Additional information on disposal
This symbol means: Do not dispose of this product together with your
household waste. Please refer to the information of your local community
or contact our dealers regarding the proper handling of end-of life electric
and electronic equipment.
Recycling of this product will help to conserve natural resources and pre-
vent potential negative consequences for the environment and human
health caused by inappropriate waste handling
