23
Measuring procedure
7. Measuring procedure
7.1 Measuring
Switch the instrument on. The display shows the
difference measurement.
Set the instrument on the sample to be measured.
Now press the Operate button to start measuring.
The beep indicates that measurement has
been completed. The display will now show the
measured values for the new sample as well as
the differences to the last measured standard. As
an alternative to the Operate button, you can use
the automatic trigger to perform the measurement.
To do this, hold the instrument as shown in the
accompanying illustration.
Press on the instrument to start measuring. The
trigger is provided for measuring inaccessible
areas. The beep indicates that measurement is
complete. You can now decide whether to store
your reading as a standard or a sample. Use the
button in the difference mode to perform a quick
standard measurement. The following message
appears on the display:
Measuring Standard
Summary of Contents for BYK spectro-guide 45/0 gloss
Page 58: ...57 Setting Custom1 Setting Custom2 Options...
Page 74: ...250 020 858 E 1105...
