56
Options
You can toggle menu options on or off by
moving the cursor to the option and pressing the
Operate button to make the check mark appear
or disappear. If you would like to allow only the
display time, beeper, and trigger to be set in the
“Setup” menu, move the cursor to each option you
wish to disable and press the Operate button.
The check marks behind these options disappear.
When you are finished with your selection, you
can store the modified menu. To do this, move the
cursor to the “Exit” option. This option appears
in the “Options” menu in place of “Configure.”
Press the Operate button, and the modified menu
is stored. The new instrument settings are taken
effect at the same time.
If you wish to reactivate “Custom1“ (or ”Custom2“)
at a later time, move the cursor to “Configure /
Custom1 (or Custom2)” press the operate button.
After the “Protected option!“ message appears,
press the
buttons simultaneously for 5 seconds. When you
open the “Setup” menu from the “Options” menu
again, only those options which were check-
marked appear now.
When shipped, Custom1 and Custom2 contain
predefined settings, which can be found on the
next page.
Summary of Contents for BYK spectro-guide 45/0 gloss
Page 58: ...57 Setting Custom1 Setting Custom2 Options...
Page 74: ...250 020 858 E 1105...
