14
Whenever your iPhone or iPod is docked and your Altec Lansing inMotion
Classic speaker system is plugged into an AC outlet, your iPhone or iPod is
charging (until fully charged) – even if the speaker system is switched off.
Listening to the FM Radio
1
extend the FM antenna fully for
best FM reception.
2
Select “FM” mode.
Press the “SOURCE” button on your
speaker system or full-featured remote
until “FM” appears on the LCD.
3
Tune to the station you want to
listen to.
Use the or buttons on your
speaker system or full-featured remote
to tune in the desired station. Press
and hold these same buttons to find the next clear FM station.
4
Adjust the volume.
Use the “+” and “–” buttons on the Altec Lansing speaker system or
full-featured remote to adjust the system volume.
How to Store Preset Stations
Your Altec Lansing speaker system’s full-featured remote enables you to
program up to 4 FM station presets:
1
Tune to the station you wish to store.
While in “FM” mode, use the
and buttons on your speaker
system or full-featured remote to tune to the desired station.
2
Store the station.
Press and hold the P1, P2, P3 or P4 button on the full-featured
remote for a few seconds. You can store one FM station in each
preset.
3
To store other stations, repeat the above steps.
How to Recall Preset Stations
1
Make sure you are in “FM” mode.
If you’re not in “FM” mode, press the “SOURCE” button on your
speaker system or full-featured remote until “FM” appears on the LCD.
2
Press a PReSeT button (P1, P2, P3 or P4) on the full-featured
remote.
The radio will tune to your preset station.
3
Adjust the volume.
Use the “+” and “–” buttons on the Altec Lansing speaker system or
full-featured remote to adjust the system volume.
Charging Your iPhone or iPod
