5
en
Getting Started
2
Allow the battery to charge.
Charging time: Approximately 4 hours for a full charge. When the
battery is fully recharged, the battery icon is shown as full.
WARNING
During the recharging process, it is typical for the battery
to become warm. To be safe, keep flammable materials away from the
speaker system.
How to Disconnect the Rechargeable Battery
1
Unplug the inMotion Classic from the wall outlet.
2
Remove the rechargeable battery compartment cover at the
back of the system by removing the screw.
3
Unplug the battery and remove it.
WARNING
There is a danger of explosion if the battery is incorrectly
replaced. Replace it only with the same or equivalent type. Do not expose it
to excessive heat such as sunshine, fire, etc.
BATTERY DISPOSAL
The battery used in this product must be properly
recycled or disposed of. Please contact your local recycling center for
proper battery handling and disposal instructions.
Rated Voltage: 3.7V Capacity: 1800mAh Type: McR18650
How to Install the Full-featured Remote Battery
The full-featured remote battery (included) is not installed at the factory. To
install the battery, follow the steps below:
1
Pull out the battery holder.
The battery door is located on the
lower end of the remote. Simply pull
the tab to open the battery holder.
2
Position the included lithium coin
battery (CR2025) battery so it sits in
the battery holder correctly.
Make sure the polarity (the + and – sides of the battery) is correct.
3
Replace the battery door.
NOTE
Please discard used batteries properly.
