Altec Lansing Moondance Glow M402SR, User Manual

19

en

7 

Set the alarm source.

Press the   or   button on your speaker system or the enhanced 
remote to select the alarm source (iPod, FM radio or buzzer). Then 
press the 

 button to save this setting and enter the Snooze 

Duration Set mode.

NOTE 

If you wish to wake up to a specific song on your iPod, dock your 

iPod on the speaker system, select the song on your iPod, and then 
select iPod as your alarm source. The speaker system should remember 
which song was selected from now on, unless the playlist on your iPod 
is modified. If the playlist on your iPod is modified, either the last song on 
queue or the first song on your song list will play. 

NOTE 

Your Altec Lansing speaker system features a backup battery. If 

a power failure occurs or the AC cord is accidentally disconnected, the 
display will not remain lit and the alarm will not function. The correct time, 
however, will be temporarily maintained (provided you have installed a 9-volt 
backup battery as described in the 

Getting Started

 section).

NOTE 

If the iPod or FM radio are playing when the alarm goes off, the 

alarm will automatically default to the buzzer, even if the iPod or FM radio 
have been selected as the alarm source.

8 

Set snooze duration.

Press the   or   button on your speaker system or the enhanced 
remote to select the snooze duration. The default snooze duration 
is 9 minutes and can be adjusted from 5 minutes to 60 minutes 
in increments of 1 minute. Then press the 

 button to save this 

setting and enter the Alarm Volume Set mode.

9 

Set the alarm volume.

Press the   or   button on your speaker system or the enhanced 
remote to select the alarm volume (low, medium or high). The default 
alarm volume is medium. Then press the 

 button to save this 

setting and exit the Alarm Set mode.

NOTE 

When exiting the Alarm Set mode, the Alarm is automatically turned 

on. To dismiss the alarm when it sounds, press and hold the corresponding  

 / 

 button for a few seconds.

How to Set Alarm 2

Repeat the above steps, substituting

for 

.

How to Use the Snooze Feature

Press the SnOOZe button once to silence the alarm for a period of 
5 to 60 minutes (user-definable).

Setting the Alarm