Micro VoIP 200
User Manual
v1.53
12
2.2 User Management
To let the IP-Phone register to Micro VoIP 200, you need to set the user accounts of all the
IP-Phones to be installed in the
User Mgmt.
page.
By clicking the
IP PBX
link, the submenu will expand. Then click
User Mgmt.
, you can see four
default users shown in the web page.
Some items/checks must be explained below:
1.
DHCP Only for IP Phones
If this check box is checked, the DHCP server in this Micro VoIP 200 will only provide IP
address to IP Phones in this user management page, the PC in the same network will not be able
to get any IP address from Micro VoIP 200. In this way, as depicted in
Figure 1
, the voice
packets from IP Phones will go through Micro VoIP 200 and data packets from Notebook/PC
will go through other NAT/Router. The default value for this field is
checked
.
If you want to use the Micro VoIP 200 as both IP PBX and NAT/Router for the office, you
need to uncheck
DHCP Only for IP Phones
checkbox. The Micro VoIP 200 will assign IP
address to IP Phones and Notebook/PC in the office network. Fig 2 depicts this usage. But this
kind of usage is not recommended.
