Micro VoIP 200
User Manual
v1.53
63
7.3 Upgrade
By clicking on the
Upgrade
page, you can do the following functions.
Firmware Upgrade
:
The firmware of Micro VoIP 200 could be upgraded if you have a newer firmware on your
Notebook/PC. Just press the
Browse
button on this page, a small window will pop up that allows
you to select the new firmware file in your PC. After the firmware file is selected, press the
Upgrade
button to do the firmware upgrade. A progress bar will pop up to display the upgrading
status. The upgrade progress will take about 4~5 minutes.
Please don’t reboot the device during upgrade.
Backup Configuration
:
By pressing
Backup
button, you can save Micro VoIP 200’s current configuration settings into a file
in your PC. The saved filename is “config.dat”.
Restore Configuration
:
The configuration of Micro VoIP 200 could be restored from the backup configuration file you
stored previously with the file name of “config.dat”. You can press the
Browse
button to select the
backup configuration file name. Then, by pressing
Restore
button, the configuration will be
restored to Micro VoIP 200. If the external USB disk is inserted and works with Micro VoIP 200, the
new settings will be restored to the flash and external USB disk at the same time.
Factory Default
:
Press the
Factory Default
will restore the flash & external USB settings to the factory default
values.
System Restart
:
Press the
System Restart
will reboot the system.