Altice Labs GR240BG User Manual Download

Page: 15 / 56

FiberGateway User Manual

This User Manual is applicable to the equipment FiberGateway Altice GR240BG
with the FCC ID: 2ACJF-FGW-GR240BG

FCC NOTICE

This device complies with FCC part 15 rules. Operation is subject to the following two conditions:
1. This device may not cause harmful interference and
2. This device must accept any interference, including interference that may cause undesired
operation of the device

Caution:

Changes or modifications not expressly approved by the party responsible for compliance could void
the user’s
authority to operate the equipment.

Note:

This equipment has been tested and found to comply with the limits for a Class B digital device,

pursuant to
Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference  in  a  residential  installation.  This  equipment  generates,  uses  and  can  radiate  radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur
in  a  particular  installation.  If  this  equipment  does  cause  harmful  interference  to  radio  or  television
reception, which can be determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
Consult the dealer or an experienced radio/TV technician for help.

This device meets the FCC requirements for RF exposure in public or uncontrolled environments.

RF Exposure Statement

Note:

This transmitter must not be co-located or operated in conjunction with any other antenna or

transmitter.
This  equipment  should  be  installed  and  operated  with  a  minimum  distance  of  8.3  inches  (21  cm)
between the radiator and your body.
This system has been evaluated for RF exposure for humans in reference to ANSI C 95.1 (American
National Standards Institute) limits.
The  evaluation  was  based  in  accordance  with  FCC  OET  Bulletin  65C  rev  01.01  in  compliance  with
Part 2.1091 and Part 15.27.
The  minimum  separation  distance  from  the  antenna  to  general  bystander  is  8.3  inches  (21  cm)  to
maintain compliance.

Compliance with FCC requirement 15.407(c)

Data transmission is always initiated by software, which is the passed down through the MAC, through
the digital and analog baseband, and finally to the RF chip. Several special packets are initiated by the
MAC.  These  are  the  only  ways  the  digital  baseband  portion  will  turn  on  the  RF  transmitter,  which  it
then  turns  off  at  the  end  of  the  packet.  Therefore,  the  transmitter  will  be  ON  only  while  one  of  the
aforementioned  packets  is  being  transmitted.  This  device  automatically  discontinues  transmission  in
case of either absence of information to transmit or operational failure.