16
IP 710 Manual
To Remove the PoE Module
1. Remove the screw on the PoE Module cover, and remove the cover.
2. Notice the “feet” on the two tabs on the lower end of the cover. Use
these feet to lift the PoE module out of the compartment: Holding the
upper end of the cover, slip the cover into either the right side or left
side of the module compartment, between the compartment and the
module, until the feet of the two tabs is under the module (the inside
of the cover should be facing toward the module).
3. Pull up to remove the module.
Miscellaneous Operation Notes
•
Logging in and out
—When using
#26
and
#27
to log out / log in, the
IP 710 must be onhook. Pressing the
Speaker
button and then using
#26
or
#27
will not work.
•
BASIC mode
—If the IP 710 phone fails to register with AltiWare
during startup, the phone operates in Basic mode. When in Basic
mode, the IP phone’s LCD display shows (BASIC) IDLE.
No AltiWare switching features are available in this operating mode.
However, the phone user can enter a destination IP address followed
by #, and make an outgoing call through the IP network to reach
AltiWare or another IP 710 phone. Also, the IP phone can accept
incoming calls originating from AltiWare or another IP 710 phone.
If the IP phone’s local configuration is changed while in BASIC
mode, the changes are overridden by AltiWare Administrator
settings.
•
Incoming call takes priority
—If a call comes in while you are using
any phone menu or display (such as workgroup display or Call Log),
the phone will exit the menu and go to the ring state.
•
Restoring default settings
—To automatically restore the original
default settings for the IP 710 phone:
1. Press the
Menu
button.
2. Press
* * 2
, then press the
Enter
button.
•
Rebooting the phone
—To reboot the IP 710 phone, press
* * 3
, then
press the
Enter
button.
Summary of Contents for 710
Page 1: ...IP 710 Phone User Manual October 2014 ...
Page 6: ...iv IP 710 Manual ...
Page 10: ...2 IP 710 Manual ...
Page 53: ...44 IP 710 Manual ...
