Alti-IP 600H Manual
26
Disabling DHCP
If you do not use DHCP in your network, you can disable DHCP before
manually assigning an IP address to the Alti-IP 600H. To disable DHCP,
use the following steps:.
Note: Procedures involving configuring IP settings cannot be completed
when DHCP is enabled in your network.
1. Press
* * 7
+
ENTER
button.
2. Use / to select
Network
, then press the
Enter
key.
3. Scroll to
Enable DHCP
.
If DHCP is enabled, the option displays as
DHCP Enabled YES
.
4. Press (DOWN key) to disable DHCP.
Configuring IP Settings
Use these guidelines when manually configuring the IP settings:
•
Ensure the default gateway IP address in on the same subnet as the host
IP address.
•
When inputting IP addresses into the Alti-IP 600H, use the
*
key to
enter periods. For example, “209.120.12.8” would be inputted as
“209*120*12*8”.
Assigning a Local IP Address
The IP address is the unique logical address identifying each host computer
on a TCP/IP network. An IP address is a 32-bit number expresses as four
decimal numbers from 0 to 255 separated by periods.
To assign an IP address, use the following steps:
1. Press
* * 7
+
ENTER
button.
2. Use / to select
Network
, then press the
ENTER
button.
3. Scroll to
Local Address
.
4. Press the
ENTER
button or (FORWARD key).
5. Use the buttons on the dial pad to enter a new IP address, using the *
key to enter periods. Use the (BACK key) to correct any mistakes.
6. Press the
ENTER
button.
Summary of Contents for Alti-IP 600H Phone
