Alti-IP 600H Manual
29
Configuring NAT
NAT (Network Address Translation) is the translation of an IP address
used within one network to a different IP address known within another
network. One network is designated as the inside network, the other is the
outside. The Alti-IP 600H can be enabled to support H.323 behind NAT.
The Alti-IP 600H will be able to work behind a regular NAT router without
any special implementation for H.323.
For more detailed information regarding NAT configuration guidelines and
implementation, refer to the
AltiWare OE/ACC
or
ACM System
Administration Manual
.
Note: If more than one Alti-IP 600H phone sits behind NAT, a VPN
tunnel is required to connect between the NAT router and the
corporate router.
Assigning NAT
By default, NAT is not enabled. If you connect the Alti-IP 600H behind a
NAT router, you may manually assign the NAT router’s public IP address
to this field.
To assign the NAT address, use the following steps:
1. Press
* * 7
+
ENTER
button.
2. Use / to select
Network
, then press the
ENTER
button.
3. Scroll to
Enable NAT
.
4. Press (DOWN key) to select
YES
.
5. Press the
ENTER
button.
6. Use (BACK key) to return to the Network menu, then select
NAT
Address
.
Use the buttons on the dial pad to enter the new NAT address, using
the * key to enter periods. Use (BACK key) to correct any mistakes.
7. Press the
ENTER
button.
Setting Ring Tones
The Alti-IP 600H Phone has three (3) ringing tones available. To set the
ring tone:
Summary of Contents for Alti-IP 600H Phone
