Altinex Tilt `N Plug Interconnect Box TNP100UK, User Manual

ACCESSORIES

2

PRECAUTIONS / SAFETY WARNINGS

1

Please read this manual carefully before using your

TNP100UK 

Interconnect Box. Keep this manual

handy for future reference. These safety instructions
are to ensure the long life of your 

TNP100UK 

and to

prevent fire and shock hazard. Please read them
carefully and heed all warnings.

1.1 GENERAL

•

  Unauthorized personnel shall not open the

unit since there are high-voltage
components inside.

•

  Qualified ALTINEX service personnel, or

their authorized representatives must
perform all service.

1.2 INSTALLATION

•

  For best results, place the 

TNP100UK

Interconnect Box in a dry area away from
dust and moisture.

•

  To prevent fire or shock, do not expose this

unit to rain or moisture. Do not place the

TNP100UK 

Interconnect Box in direct

sunlight, near heaters or heat radiating
appliances, or near any liquid. Exposure to
direct sunlight, smoke, or steam can harm
internal components.

•

  Handle the 

TNP100UK 

Interconnect Box

carefully. Dropping or jarring can damage
internal components.

•

  Never place fingers inside the opening  on

each side of the unit. This action could
cause serious injury because of the sharp
edges inside of the 

TNP100UK

.

•

  Do not place heavy objects on top of the

TNP100UK

.  Do not use excessive force to

push down on the top of the unit.

•

  To turn off  the  main power, disconnect the

power cord, which powers the power socket
on the 

TNP100UK

 pop up panel only.  The

power outlet socket should be installed as
near to the equipment as possible, and
should be easily accessible.

•

  We recommend using wall outlets with a

Ground Fault Circuit Interrupter (GFCI) for
maximum protection.

•

  Install all cables according to the

instructions.  Do not force or pull  out any
cable or power cord that is attached to the

TNP100UK 

Interconnect Box.

1.3 CLEANING

•

  Surfaces should be cleaned with a dry cloth.

Never use strong detergents or solvents,
such as alcohol or thinner. Do not use a wet
cloth or water to clean the unit.

1.4 FCC / CE NOTICE

•

  This device complies with  part 15 of the

FCC Rules. Operation is subject to the
following two conditions: (1)  This device
may not cause harmful interference, and (2)
this device must accept any interference
received, including  interference  that  may
cause undesired operation.

•

  This equipment has been tested and found

to comply with the limits for a Class A digital
device, pursuant to  Part 15 of  the FCC
Rules. These limits are designed to provide
reasonable protection against harmful
interference when the equipment is
operated in a commercial environment. This
equipment generates, uses, and can radiate
radio frequency energy and, if not installed
and used in accordance with the instruction
manual, may cause harmful interference to
radio communications. Operation of this
equipment in a residential area is likely to
cause harmful interference in which case