INSTALLATION INSTRUCTIONS / INSTRUCTIONS D’INSTALLATION
AFS-700 LED Follow Spot
4
Installation and Set Up
AFS-700 LED Follow Spot Tripod / Fixture Movement
The AFS-700 LED Follow Spot is supplied with a foldable metal tripod and mounting hardware. When in use you must place the
tripod on a solid, steady surface that is capable of supporting the weight of the tripod (approximately 12 lbs / 5.5 kg), fixture 38.3lbs /
17.4 kg), cabling, and accessories as well as the operator.
• You must follow and adhere to all local and national safety requirements, regulations, and codes when using this fixture.
• When selecting an installation location, consider ease-of-access to the fixture for operation, programming adjustments, and rou-
tine maintenance.
• Never mount or use the AFS-700 LED Follow Spot where it will be exposed to moisture (rain, high humidity, etc.), extreme tem-
perature changes, hazardous conditions, or restricted ventilation.
• It is a good practice to add sand bag weights (by others) over each leg of the tripod to steady the fixture when moved.
Figure 2: AFS-700 LED Follow Spot Tripod / Fixture Movement
The fixture simply secures to the tripod via the tripod mounting bracket with the provided hardware.
Step 1. Place tripod in a suitable location following the information above.
Step 2. Set tripod to desired height.
Step 3. Using two people, lift AFS-700 LED Follow Spot and position the tripod mounting bracket’s hole over stud on tripod.
Step 4. Hand-tighten provided knob securing fixture to tripod.
43.8 in. /
111.2 cm
5.7 in. /
14.4 cm
Ø 4'-0"
ALTMAN LIGHTING
AFS-700
30°
30°
45°
45°
BALANCING POINT
TRIPOD MOUNTING
BRACKET
WARNING!
Unless legs are weighted
down or secured to the floor, do not
operate the tripod stand without the
legs fully extended.
54.3 in. /
137.9 cm
27.1 in. /
68.9 cm
27.2 in. /
69.0 cm
42.9 in. /
109.0 cm *
*
Legs fully extended.
Pan Lock location:
(manual) for locking pan
movement of the follow
spot.