Connecting to the DMX512 Network
7
AFS-700 LED Follow Spot
INSTALLATION INSTRUCTIONS / INSTRUCTIONS D’INSTALLATION
Connecting to the DMX512 Network
The AFS-700 LED Follow Spot offers two DMX512 connections. One for DMX Input (from a DMX source) and one DMX throughput
(out). Basic DMX512 installation consists of connecting multiple DMX controlled AFS-700 LED Follow Spots together (up to 32 Total
devices per DMX string) in “daisy-chain” fashion. A cable runs from the DMX512 control source to the DMX INPUT connection on the
first luminaire. From the DMX OUTPUT of the luminaire another cable runs to the DMX IN connector on the next luminaire (or
DMX512 device to be controlled).
IMPORTANT!
At the end of each DMX Daisy chain, it is highly recommended that a DMX TERMINATOR (Altman Lighting part
number DMX-5-TERM) is installed on the last luminaire (or device) in the chain.
For more information on installing DMX512 control systems, the following publication is available for purchase from the United States
Institute for Theatre Technology (USITT), “Recommended Practice for DMX512: A Guide for Users and Installers, 2nd edition” (ISBN:
9780955703522). USITT Contact Information:
www.usitt.org
DMX - XLR Connectors
shows the pin outs and corresponding DMX signals for a 5-pin XLR connectors.
Note:
* Only those pins shown are used. Remaining pins are not used.
Controlling with Control Panel
The AFS-700 LED Follow Spot’s functions can be controlled by either DMX or the AFS-700 LED Follow Spot control panel (refer to
"AFS-700 LED Follow Spot Control Panel" on page 5
The AFS-700 LED Follow Spot control panel can be used in conjunction with more than one AFS-700. This layout will allow one
“lead” follow spot operator to control automated the functions of additional AFS-700 LED Follow Spot luminaires. Note, the control
panel does not control the manual pan and tilt functions of the AFS-700 LED Follow Spot which requires an operator at every follow
spot location.
To set up:
Step 1. Set all AFS-700 LED Follow Spot luminaires to DMX address (Adr.) to 001.
Step 2. Connect AFS-700 LED Follow Spot control panel to the lead follow spot DMX input connector.
Step 3. Follow DMX daisy chain rules for adding additional AFS-700 LED Follow Spots.
IMPORTANT!
WHEN OPERATING FROM THE CONTROL PANEL:
DO NOT ADD ANY OTHER LUMINAIRE TYPES OR
OTHER DMX CONTROLLED DEVICES TO THIS FOLLOW SPOT DATA LAN AS IT WILL RESULT IN UNWANTED RESULTS.
MENU SYSTEM
IMPORTANT!
This section provides basic information regarding the AFS-700 LED Follow Spot’s menu system. For detailed
information on the menu system and settings, please visit the AFS-700 LED Follow Spot page on the Altman Lighting web site at
www.altmanlighting.com
or scan the QR code on the first page of these instructions.
Menu Overview
The AFS-700 LED Follow Spot has an on-board menu system that allow users to set up the luminaire for standalone operation,
control via DMX, or control a variety of luminaire features. This section will cover the on-board menu system. Refer to
Follow Spot Back Panel" on page 5
Menu System & Settings
outlines the AFS-700 LED Follow Spot menu system and settings.
On startup (approximately 45 seconds), the menu display on the rear of the AFS-700 LED Follow Spot will display a startup screen.
Once the unit completes its boot up, you can then access the menu system and settings.
Table 3: DMX RJ45 & XLR Connector Wiring
DMX XLR Connectors Pin Out
DMX Signal
Pin
Common (Drain)
Pin 1
DMX -
Pin 2
DMX +
Pin 3
