Altman AFS-700, Installation & User Manual

Overview

5

AFS-700 LED Follow Spot

INSTALLATION INSTRUCTIONS / INSTRUCTIONS D’INSTALLATION

AFS-700 LED Follow Spot Back Panel

Figure 3:  AFS-700 LED Follow Spot Back Panel

AFS-700 LED Follow Spot Control Panel

Figure 4:  AFS-700 LED Follow Spot Control Panel

Menu LCD 

- shows states and allows 

user set up. See 

"Menu System" 

on page 7

.

Down Button 

- for menu 

control / scrolling trough 
options.

ESC (Escape) Button 

- 

for menu control / back 
out of an option or screen.

Enter Button 

- for menu control 

/ for accessing an option or 
selection of a setting.

DMX Input 

- 5-pin connector 

for DMX512A input signal.

Note: the AFS-700 follow spot 
control panel will plug directly 
into the DMX input connector 
when the unit is not connected 
to a DMX network.

DMX Output 

- 5-pin connector 

for DMX512A output / through 
signal.

Power Switch 

- for turning fixture on 

and off.

Fuse Compartment

 - 

replaceable fuse. Replace 
with fuse indicated on fixture.

AC Input 

- for supplying power to unit. Se

"Power and Data Connections" on
page 6

 for details.

Up Button 

- for menu 

control / scrolling trough 
options.

WHITE

RED

GREEN

DIMMER

STROBE

CTO

IRIS

FOCUS

ZOOM

PINK

AMBER

BLUE

LT. AMB.

LAV.

LAMP

ON/OFF

Dimmer Slider 

- for controlling 

intensity.

Lamp On/Off 

- turns 

on and off the LED 
source only. Note: 
does not affect any 
other operation of the 
fixture.

Color Filter Buttons 

- for selecting color filters. Note: selecting two 

adjacent color selection buttons will result in a split or half-tone color 
except for Violet and White. Violet and White cannot produce a split 
or half-tone color with each other.

Strobe Slider 

- for controlling strobe rate. 

See 

Table 1, “Strobe Operation (via 

control panel),” on page 6

CTO Slider 

- for controlling color temperature of 

the light output. Rotates CTO wheel for 5600K, 
4500K, and 3200K.

White Button 

- White light 

output (no color filter).

Zoom Slider 

- for controlling 

zoom - adjusts the size of the 
beam from 7° to 13°.

Focus Slider 

- for controlling 

fixture beam focus.

Iris Slider 

- for opening and closing 

fixture’s iris.

NOTE:

- 

each of the AFS-700 control attributes may be turned off 

via the rear display see- Personalities on Page

 8 of this manual.