C A R E A N D C L E A N I N G
Care and Cleaning
The cleanliness and appearance
of this unit will contribute
considerably to operating
efficiency and savory, appetizing
food. Good equipment that is
kept clean works better and lasts
longer.
THOROUGHLY CLEAN THE DISPLAY
CASE DAILY
A. Turn lights and adjustable thermostat(s) to the
“OFF” position, and
disconnect unit from power
source.
B. Remove, cover or wrap,
and store unused products
under refrigeration.
C. Clean the interior metal
surfaces of the cabinet with
a damp clean cloth and any
good commercial detergent
or grease solvent at the recommended strength.
Use a plastic scouring pad or oven cleaner for
difficult areas. Rinse surfaces by wiping with a
sponge and clean warm water to remove all
detergent residue. Wipe dry with a clean cloth or
air dry.
NOTE:
Avoid the use of abrasive cleaning
compounds, chloride based cleaners, or
cleaners containing quaternary salts. Never
use hydrochloric acid (muriatic acid) on
stainless steel.
D. Clean the glass with a window cleaner. The
sliding glass doors are removable allowing for
easier cleaning.
E. To help maintain the protective film coating on
polished stainless steel, clean the exterior of the
unit with a cleaner recommended for stainless
steel surfaces. Spray the cleaning agent on a
clean cloth and wipe with the grain of the
stainless steel.
Always follow appropriate state or local health
(hygiene) regulations regarding all applicable cleaning
and sanitation requirements for equipment.
Remember to turn the breaker switch(es) ON again
before operating the unit.
#884b - CC-72/BKR and CC-96/BKR Display Units - Operation & Care Manual • 9
AT NO TIME SHOULD THE INTERIOR OR
EXTERIOR BE STEAM CLEANED, HOSED
DOWN, OR FLOODED WITH WATER OR
LIQUID SOLUTION OF ANY KIND. DO NOT
USE WATER JET TO CLEAN.
S E V E R E D A M A G E O R E L E C T R I C A L H A Z A R D
C O U L D R E S U LT.
WARRANTY BECOMES VOID IF APPLIANCE IS FLOODED.
The performance of this unit has been
optimized using the factory provided bulbs.
These bulbs should be replaced with an
exact replacement or with a factory
recommended replacement. These bulbs
have been treated to resist breakage and
must be replaced with similarly treated
bulbs in order to maintain compliance with
NSF standards. DO NOT over-tighten bulbs
in their receptacles as this can cause
damage to the bulb filament.
