3.2 The Rear Panel
(10). FUSE HOLDER / VOLTAGE SELECTOR
This is a dual voltage unit. Before you attempt to connect and operate the unit, please make sure that your local
voltage matches the voltage on the fuse-holder cover.
TIP
RING
SLEEVE
CHANNEL 5
OUTPUT
INPUT
OUTPUT
INPUT
TIP
RING
SLEEVE
AC INPUT
95-120V~/210-240V~60-50Hz
Rated Power Consumption 15W
FUSE:
210-240V:T200mAL 250VAC
95-120V:315mA 250VAC
REPLACE FUSE WITH
CORRECT TYPE ONLY
Apparaten skall anslutas till
jordat uttag nar den ansluts
till ett natverk
OUTPUT
OUTPUT
OUTPUT
RIGHT
RIGHT
INPUT
INPUT
INPUT
LEFT
LEFT
PIN 2
PIN 1
PIN3
OUTPUT
INPUT
PIN 2
PIN 1
PIN3
PIN 2
PIN 1
PIN3
PIN 2
PIN 1
PIN3
PIN 2
PIN 1
PIN3
PIN 2
PIN 1
PIN3
CHANNEL 6
CHANNEL 1
CHANNEL 3
CHANNEL 4
MAIN IN
CHANNEL 2
MAIN OUT
A101
110-120V
220-240V
1
2
3
1
2
3
1
2
3
1
2
3
1
2
3
1
2
3
1
2
3
10
11
15
14
13
12
5
Caution:
The fuse protecting the AC supplies circuits of this unit. The fuse can only be changed by a qualified
technician, in the event of a fault or changing the supply voltage. If the fuse continues to blow
after replacing, discontinue use of this unit before repaired.
110-120V
220-240V
THIS IS SET FOR
110V AC TO 120V
AC OPERATION
THIS IS SET FOR
220V AC TO 240V
AC OPERATION
220-240V
110-120V
(5). OUTPUT LEVEL meter
This 4-digit meter tells you the level of the main output signal. While the Clip LED lights up, please turn down
the main signal at either each input stage or the main output stage, otherwise, the system will be distorted.
(6). SPLIT / MIX
Use this switch to select the specific operational mode for each individual mono channel.
For SPLITTER mode, please let the switch released, and the main input signal can then be split into each mono
channel output.
For MIXER mode, please engage this switch, and now, the mono channel input signal will be sent to the main
output bus, combined with the main input signal on condition that the MAIN LINK is activated, you can get the
mixed signal output from the MAIN OUT sockets.
Further, also for the MIXER mode, you can route the mono channel input signal to the mono channel output
directly.
(7). LEVEL control for each channel
This knob is used to adjust the level of each mono channel, and its adjustable range goes from -
to +15dB,
definitely,
In SPLITTER mode, this control is used to determine the output level of each individual mono channel.
While in MIXER mode, this control can be used to determine how much the mono channel input signal is sent
to the main output bus and/or each individual mono channel output.
(8). INPUT / OUTPUT LEVEL meter
This 4-digit meter tells you the output level of each mono channel, while the Clip LED lights up, please turn
down the level control, otherwise, this channel will be distorted.
(9). BALANCE / PAN control
Generally, the main section uses the stereo input and output, while, for each individual channel, mono application
is configured.
So, if the stereo main signal is split into the mono channel output, or the mono input signal is routed to the
stereo main output bus, please use this knob to determine the proportion between the left and the right.
