17
5.4.2 COMM. SETUP SUBMENU
This submenu allows access to the setting of communication with other units via the serial ports.
PRESET Change RX
Allows to accept or ignore the PRESET Change command sent via the serial ports from a computer or another
MAXI-Q when it loads a PRESET.
The settings can be:
Ignore PRESET Change commands received. Accept and execute PRESET Change commands.
Comm. Setup
Preset Change RX
Comm. Setup
Preset Change RX
Preset Change RX
ID Select
C
m
o
. S
t u p
m
e
P
e
r
e t
C h a
s
n g e
R X
A c c e p t
P
e
r
e t
C h a
s
n g e
R X
I g n o r e
ACCEPT
..
#2 MySetup
#3 MySetup5
#4 LiveSet1
#5 LiveSet2
#6 Monitor
#7 Monitor2
#8 Monitor3
#9 Side
..
Preset Change RX
MAXI-Q #2
MAXI-Q #1
IGNORE
..
#2 SideField
#3 Concert1
#4 Concert2
#5 Concert3
#6 Concert4
#7 Remote1
#8 Remote2
#9 Remote2
..
Preset Change RX
MAXI-Q #3
SERIAL
PORT
SERIAL
PORT
SEND
..
Preset #2
Preset #3
Preset #4
Preset #5
Preset #6
Preset #7
Preset #8
Preset #9
Load Preset
..
The PRESET Change command is completely identical to MIDI Program Change: the transmitting unit
sends an instruction containing a number of PRESETS to load; the receiving units (if they are able to accept
the command) each loads into its own memory the PRESET with the corresponding number.
This means that, in a chain of MAXI-Q, all the units set with PRESET Change RX = Accept load the same number
of PRESET, in spite of the fact that it corresponds to PRESETS with different contents in the various units.
5.4.3 Misc. Setup submenu
Output Meters
Misc. Setup
Temperature
LCD Contrast
