8
4.5 First Setup
checks
Disable the MUTE function
on the outputs you intend using and listen the sound, carry out instrumental
(if you have the necessary equipment) and any corrections required.
Firstly, set the following parameters
in order:
shown
Output Pol.
Polarity of the outputs
Output Gain
Levels of the outputs
Then, adjust the values of the following functions:
EQ TYPE:
Link or UnLink.
Graphical/Parameter EQ:
30 groups of Graphical EQ or 5 groups of Parameter EQ.
At this point, the first custom setup can be prepared.
The following is only the description of setup procedure.
The detailed specifications of each parameter are shown in the respective paragraphs of the manual.
Note:
The regulation of the MAXI-Q's parameters is closely related to the characteristics of the components
of the sound system. So if you're not the expert, please refer to the documentation and technical
specifications of your power amplifiers, loudspeaker enclosures, monitors, etc.. This will enable
you to work faster and safely.
Note:
In this first phase of setting up your sound system, the adjustment of these functions (which if not Indis-
pensable during installation) can wait. But do remember that adjusting the equalizers can also affect the
signal level. So if considerable equalization changes are made, remember to check and adjust the output
4.6 System configuration
The bold letters indicate the inputs:
A
= Input A
B
= Input B
levels too, if necessary.
Numbers
indicate the respective outputs.
1 and 2
Note:
The signal connected to Input
is always assigned to outputs .
A
1
The signal connected to Input
is always assigned to outputs .
B
2
(example)
A 1
B 2
2
F
D E B A S S
The display will show the
(according to the configuration
INA Gain
and other utilities loaded in the memory)
Press
ENTER.
I N A
G A I N
. 0 d B
0
I N A
G A I N
. 5 d B
2
-
Use the
to change the gain value and watch the level of the signal on the LED ladders until the ideal values
DIAL
are reached.
Then use the
and
keys to access to the
page (if there is one, this will depend on the con-
PREV
NEXT
INB Gain
figuration and the other utilities loaded in the memory).
Repeat the settings as explained above.
