Press
ENTER.
11
A 1 3
F
2
B 2 4
2 x 2 W
The system returns to default status and the display shows the information on the PRESET that has just been
loaded.
Note:
Factory PRESET #2
In the example,
, named "2x2W" has been loaded: Its system configuration is Input A
signal assigned to outputs 1 and 3; Input B signal assigned to outputs 2 and 4.
5.1.2 Store & Naming PRESET
Use this menu to create new PRESETS, i.e. to save all the current system settings.
To save a PRESET:
Press
The
page appears, by means of which it s possible to edit the name of the
ENTER.
PRESET Naming
PRESET to be saved.
The name of the 'start' PRESET (i.e. of the PRESET currently loaded) is proposed as default. The cursor takes up
position on the first of the twelve character spaces available.
At this point:
If you decide to accept and confirm the name suggested, press
ENTER.
If you want to abort
procedure (for example because you've chosen the wrong memory area) and
Naming
return to Store PRESET procedure, press
.
ESC
S t o r e
2
U
P r e s e t
S t o r e
3
U
P r e s e t
Use
to reach the memory area in which the PRESET is to be saved.
DIAL
Note:
Factory PRESET
Factory PRESETS
Factory PRESET,
User PRESET
User
In this procedure, the
areas aren't available, since the
can not be
permanently remember that it is possible to load a
modified. Nevertheless save it in a
area, modify it as required and then store it again in the same
area.
Note:
PRESETS
Scrolling through the memory areas, the display shows the number, type and name of the
contained in them:
P r e s
m
n
i
N a
e t
g
D e f a u l t
D e f a u l t
D e f a u l t
