22
5.3.7 Output Limiter
a. Output level limiter
Allows to keep the signal of each individual output within a set level.
Can be used effectively to protect the components of a sound system.
The following editable parameters are available:
Normal: leaves the phase unchanged
Reverse: shifts the phase through 180 , inverting it.
O P 1
N o r m
P O L A
a I
R I T Y
O P 1
e v e r
P O L A
s e
R I T Y
R
O u t p u t
C o m p L i m
The effect of this control is summed with that of the
parameter of the
filter (
menu), which
LPF
Xover - EDIT
operates with 5 steps in a range of between 0 and 180 .
In this way it's possible to set the phase of each individual output with 5 steps within a complete 360 revolution,
a very useful function when assembling arrays of speaker enclosures, in the control of the interpolation between
various enclosures or between sections of the same system.
5.3.6 Output Gain
Output level control
Allows to adjust the signal level of each individual output.
Editing values are between
+6dB ~ -30dB, with 0.5dB steps.
5.3.6 Output Pol
Controls the output's polarity.
Allows to invert the phase of the signal of individual outputs.
Editing values are:
O u t p u t
G a i n
O P 1
- 6 . 5
G A I N
d B
O u t p u t
P o l
Note:
The level of each output is shown by the respective OUTPUT LEVEL LED ladder. To avoid distortion, don't
let the red CLIP LED light up. As automatic protection, you can also enable the LIMITER (EDIT menu) on
the outputs that require it. In this case, remember that enabling the LIMITER changes the display mode
on the
level, but the level of
relative LED ladder: in fact, the level shown is no longer the absolute output
the signal In relation to the LIMITER threshold.
