30
30
After entering the password, press
ENTER.
Confirmation is only accepted if the cursor is positioned on one of the passwords four characters.
Note:
This
allows to avoid accidental enabling, without having seen the password.
Protection is enabled and the system takes up default status.
How to disable the
protection
If the protection is enabled, when the system is in default status (i.e. when none menu
are lit and
LEDs
therefore
no type of editing is enabled), the following appears on the display:
L O C K
r
i
t
a l
P a s s w o r d
[ B I R D ]
P a
L O C K
P a s s w o r d
[ 1 2 3 4 ]
r
i
t
a l
P a
Total Protection enabled
T
A 1 3
B 2 4
S 5 6
2
U
2
2 W + 2 M A X
Partial Protection enabled
P
A 1 3
B 2 4
S 5 6
2
U
2
2 W + 2 M A X
Note:
in the event of an incorrect password, the display prompts again, encrypting all the characters again.
IMPORTANT!
,
If you can't remember the password there is an easy way for you to unlock the protection.
Turn the unit on, and almost "at the same time", press "PREV" and "
" keys. Now, the protection is unlocked.
To unlock the protection:
Access the
submenu.
LOCK
The display shows the prompt for entering the password to unlock the protection.
The four alphanumeric characters of the password are encrypted.
Note:
M
alongside the symbol of Total or Partial protection, the letter
may also appear. This means that the system
is protected, but the PRESET in question has undergone one or more changes that have not yet been
stored. You can however switch the system on and off without any problems, as the current settings are
kept in the buffer memory. Nevertheless, if this is your work setup, it's advisable to store it in a PRESET.
Enter in the
using the combination of the
keys and the
then press
password
and
DIAL,
ENTER.
T
M
A 1 3
B 2 4
S 5 6
2
U
2
2 W + 2 M A X
U N L O C K
[ * * * * ]
P a s s w o r d
U N L O C K
[ B I R D ]
P a s s w o r d
