5
7.ENTER key
The key allows you to access to the selected editing
. P
ou can edit and confirm
value of parameter.
page
ressing this key, y
the required
9.Input Level LED Meters
The LEDs are used to indicate the level of input A/B. In order to get an up-front distortion-free signal, you keep
the signal quite high, but do assure that the red CLIP LED doesn't light up continually.
10.Mute switches
There are six mute switches (1-6). They are used to mute the signal of the respective outputs. When the switch
is on, the corresponding led will light up. These switches can avoid signal peaks when switching on and off the
sound system and isolate the individual audio sections during testing or checking sound, etc.. The restored Mute
function can be set to use the Wake Up Function (Utility menu Misc. Setup submenu) and can be set as Normal
(last setting before the unit was switched off) or Mute (all outputs automatically forced into Mute status).
3.2 The Rear Panel
17
12
18
13
14
15
16
8.ESC key
The key allows you to exit the selected editing page. It also used to reject the value to enter and return to the
stored value.
11.Output Level LED Meters
These LEDs indicate the level of the respective outputs (you can adjust the output via adjusting the Output Gain
parameter of Edit menu.)
Note: The LIMITER on any output will change the way in which the level is displayed on the corresponding LED.
In fact, the level shown on the ladder is no longer the "absolute" output level, but the level of the signal at -24dB,
-12dB, -6dB compared to the limiter threshold (indicated by the orange LIMIT LED).
12.AC inlet and fuse holder
13.Power Switch
The switch is used to turn the main POWER on and off. Note: before turning on the unit, please make sure the
amplifiers of the sound system are off to avoid the annoying and sometimes dangerous signal peaks.
Use it to connect your MAXIDRIVE3.4 COMPACT to the supplied AC cord. Please check the Voltage in your
country and what voltage for your MAXIDRIVE3.4 COMPACT is configured before attempting to connect the
unit for the main AC. The fuse can protect the AC supplies circuit of the equipment.
CAUTION:
If there is something wrong with the fuse or the fuse needs to change, please refer to a qualified
technician. If the fuse continues to blow after replacing, discontinue using of this unit before being repaired.
Apparaten skall anslutas till
jordat uttag nar den ansluts
till ett natverk
PWR
OFF
ON
AC INPUT
14W
95-240V
50/60Hz
FUSE: 95-120V T500mAL
210-240V T315mAL
RS485 OUT
RS485 IN
RS232
INPUT A
INPUT B
4
3
2
1
OUTPUTS
5
6
A102
PUSH
2
1
3
NEW
TIDE
PUSH
1
3
2
NEW
TIDE
PUSH
1
3
2
NEW
TIDE
14.RS485 OUT
This is the standard serial communication interface port. It allows outgoing communication between a MAXIDRI-
VE3.4 COMPACT and PC or other MAXIDRIVE3.4 COMPACT units. The RS485 interface is very suitable for
remote control over long distances (difficult with RS232 standard ports) and daisy-chaining several MAXIDRIVE
3.4 COMPACT.
