40
SSB 400 W
SSE 400 W
SSB 480 W
SSE 480 W
Control/Operation
2.2.2 Scrubbing
SSB 400 W/SSE 400 W:
• Turn suction nozzle lock in
direction of arrow.
SSB 480 W/SSE 480 W:
• Raise suction nozzle.
• Switch on
-
Spraying pump and
-
Brush drive
in sequence.
2.2.3 Connecting accessories
• Connect suction and
spraying hoses to back of
machine.
• Move selector lever into
vertical position.
• Switch on spraying pump
and suction unit.
2.3
Monitoring operation
In order to avoid damage to the
floor or the machine, the brush
must never run dry.
Add sufficient cleaning liquid
during machine operation.
Drain the dirty water tank with
the discharge hose after using
up the cleaning agent. The
suction unit could be destroyed
by the penetration of water
when the tank is overfilled.
The machine must be switched
off before emptying the dirty
water tank.
After emptying:
• Refit sealing cap of
discharge hose firmly.
• When dirty, rinse sieve in
the tank cover with clean
water (otherwise suction
power is reduced).
• Check wiping lips on suction
nozzle for dirt deposits
(paper, cigarette ends, sand
etc.) before refilling
machine and putting into
operation again.
