9
5.2 X23 3-Way Mono
HIGH
MID
LOW
To get such a typical application, configure your system and connect the wires in the following proper steps:
1.Press the mode switch to enter into the 3-way mono mode.
2.Apply the mono program sources from the Mixer to the input connector of channel1.
3.Output the Low frequencies signal to the power amplifier.
4.Output the Mid frequencies signal to the power amplifier.
5.Output the High frequencies signal to the power amplifier.
6.Power up the X23 first, then the power amplifier to run the system. While powered off, please ensure the power
amplifier is turned off first, then the X23.
110-120V
220-240V
HIGH
PHASE
HIGH
PHASE
MODE
CD
BOOST
CD
BOOST
STEREO MONO
CHANNEL 2
CHANNEL 1
HIGH OUT 1 / (NOT USED)
HIGH OUT 2 / (HIGH OUT)
LOW OUT 2 / (MID OUT)
INPUT 2 / (NOT USED
)
LOW OUT1 / (LOW OUT)
INPUT 1 / (INPUT)
PUSH
2
1
3
NEW
TIDE
PUSH
2
1
3
NEW
TIDE
2WAY- STEREO
(3WAY- MONO)
/
AC INPUT
95-120V
/210-240V
60-50Hz
Rated Power Consumption 8.5W
FUSE:
210-240V: T100mAL 250VAC
95-120V: 200mA 250VAC
REPLACE FUSE WITH CORRECT
TYPE ONLY
Apparaten skall anslutas till
Jordat uttag nar den ansluts
Till ett natverk
A101
