15
16
17
3.2 The Rear Panel
Ch1 Line Input (Linked XLR-F&jack)
Ch1 Constant Directivity Boost
Ch1 LOW Output (Linked XLR-M&jack)
Ch1 HIGH Phase Inversion
Ch1 HIGH Output (Linked XLR-M&jack)
Ch2 Line Input (Linked XLR-F&jack)
Fuse Holder
Line Input (Linked XLR-F&jack)
Constant Directivity Boost
Low Output (Linked XLR-M&jack)
MID hase Inversion
P
(not used)
(not used)
(not used)
MID Output (Linked XLR-M&jack)
HIGH Phase Inversion
HIGH Output (Linked XLR-M&jack)
Ch2 Constant Directivity Boost
Ch2 LOW Output (Linked XLR-M&jack)
Ch2 HIGH Phase Inversion
Ch2 HIGH Output (Linked XLR-M&jack)
Stereo / Mono Mode
AC Inlet
18
19
20
21
22
23
24
25
26
27
28
29
30
X23
2-way stereo / 3-way mono active crossover
2-WAY STEREO MODE
3-WAY MONO MODE
Power switch
Turn the power on or off.
Mute switch
These buttons are used to mute each kind of frequencies outputs.
5
HIGH Gain
HIGH Mute
Ch2 HIGH Gain
Ch2 HIGH Mute
Ch2
C
Range
LOW-HIGH
rossover
MID-HIGH Crossover Range
19
18
30
29
28
26
27
25
24
22
23
21
20
Clip LED
110-120V
220-240V
HIGH
PHASE
HIGH
PHASE
MODE
CD
BOOST
CD
BOOST
STEREO MONO
CHANNEL 2
CHANNEL 1
HIGH OUT 1 / (NOT USED)
HIGH OUT 2 / (HIGH OUT)
LOW OUT 2 / (MID OUT)
INPUT 2 / (NOT USED
)
LOW OUT1 / (LOW OUT)
INPUT 1 / (INPUT)
PUSH
2
1
3
NEW
TIDE
PUSH
2
1
3
NEW
TIDE
2WAY- STEREO
(3WAY- MONO)
/
AC INPUT
95-120V
/210-240V
60-50Hz
Rated Power Consumption 8.5W
FUSE:
210-240V: T100mAL 250VAC
95-120V: 200mA 250VAC
REPLACE FUSE WITH CORRECT
TYPE ONLY
Apparaten skall anslutas till
Jordat uttag nar den ansluts
Till ett natverk
A101
It means that some band has resulted in clipping distortion when the LED is glittering. It is regarded as normal
if it is glittering only one or two times. But if it lasts for a long time, you should reduce the input signal to avoid
audio distortion.
