7
b. In Line Connection
4. INSTALLATION & CONNECTION
4.1 Mains Connection
standard IEC receptacle. It meets all of the international safety certification requirements.
4.2 Audio Connection
a. Wiring Configuration
Either the 1/4" TRS (Tip-Ring-Sleeve) jack or the XLR servo connector can be wired in balanced and
modes. Please wire your systems as the following examples:
unbalanced
For 1/4" Phone jack
For XLR connector
XLR Type Unbalanced
XLR Type
alanced
B
Pin3 (-)
Pin2 (+)
Pin1 ( )
(Linked to Pin1 manually,
)
Pin1 ( )
Pin2 (+)
Pin3 (-)
TS Type Unbalanced
Sleeve
Tip
+
TRS Type Balanced
Tip
Ring
Sleeve
+
-
TRS Type Unbalanced
Tip
Ring
Sleeve
+
Balanced
Tip
Ring
Sleeve
Tip
Ring
Sleeve
Tip
Ring
Sleeve
1
2
3
1
2
3
1
2
3
TIP RING SLEEVE
SLEEVE RING TIP
TIP RING SLEEVE
2
1
3
1
2
3
1
2
3
Please ensure that the
LTO X23 Active Crossover is set to the correct supply voltage before plugging the power
cord into the wall outlet, use the same fuse as marked on the fuse holder at the AC power connection socket.
The mains connection of the
LTO X23 Active Crossover is made by using the enclosed mains cord and a
The
presents with balanced XLR
connectors, and it can be interfaced
LTO X23 Active Crossover
and 1/4" TRS
by several ways to support a variety of applications without any signal loss.
For these applications, the X23 Active Crossover provides XLR connectors to easily interface with most profe-
ssional audio devices. Follow the configuration examples below for your particular connection.
