22
Frame Assembly
7
Before you position your sections onto the aluminium base you should drill the pilot holes in the
bottom of the end gable side corner bars (EV0502 / EV0503) shown in diagram 28. The position of
these holes should be about 19mm from the side face and 30mm measured from the bottom end of
the bar.
You can now position the end gable section on the aluminium base, you will need a helper to hold
this in place or simply strap it to a set of steps.
Now offer the side assembly (or side 4’/8’ extension assembly if
your model is longer than 12’) slotting the corner bar onto the end
of the eaves bar, do not fix this joint as it will be done at a later
stage (diagram 27). Screw the bottom of the corner glazing bar to
the end of the cill (80mm screw) making sure the rebate for the
glass lines up with the front face of the side cill (diagram 28).
Once the side corner bar is in place this will give you the correct
position on the aluminium base and you can fix the base to the side
cill with 25mm Pan Head screws (EV0331) (diagram 26).
Dia. 27
Dia. 28
Diagram 26
25m
m Sc
rew
Side Cill
Side Bas
e
EV0501
Internal
