59
Optional Auto Louvre Installation
16
You now need to mark
the frame to drill the 2
holes, use a 2.5mm drill
bit for this.
Offer the opener up to
the frame with the plates
and washers and slide
the louvre arm into
position. This now gives
you the correct location
for the opener (diagram
82). Once you have
marked the frame
remove the opener to
drill the holes.
Now fix the opener to
the frame using the 2
plates and 2 washers
(diagram 83). You
should have either
19mm or 25mm screws
s p a r e f r o m t h e
greenhouse frame for
this.
Once fixed in place
attached the louvre arm
to the opener and hold
in place with the plastic
pop-on cap (diagram 84).
Diagram 82
Diagram 83
Diagram 85
Diagram 84
Now slide the cylinder onto
the shaft attached to the
body of the opener, secure
this in place with 2 grub
screws (diagram 84).
Finally fit the thumb screw
to the end of the cylinder,
adjust this to get the
desired amount of
ventilation (diagram 85).
Grub
Screw
Pull down here
while adjusting
thumb screw.
Summary of Contents for VICTORIAN OAKHAM
Page 1: ...12 15...
Page 57: ...57 Finished installation 15...
