1411 S. Roselle Rd. Schaumburg, IL 60193 Phone (847) 923-0002 Fax (847) 923-0004
Configure
:
System will be Configured
with default settings. To change those settings press the “Config” button on the switch panel screen
.
Brightness
–
Sets screen brightness
Sleep
–
Turns screen off when no user press for sleep time. Press anywhere on
screen to turn back on. Can also be controlled by ignition signal.
Security Enable
–
Activates optional Lock Screen and Manual Sleep.
Enable 16 Ch
–
Activates second module when installed
Ign/Switch Power
–
Enables external ignition or switch input into external IGN terminal
to control system power up and down (
Sleep
).
Display Amps
–
Activates displaying current level for each switch channel.
Blue Tooth
–
Bluetooth setup for BT control,
optional
.
Select Channel
- Press to see list of available switch
Channels
, then select channel to
modify
Not all features are available for all circuits.
Channel
–
Displays channel name.
Pick button
: Use +/- buttons to cycle thru preset buttons
Custom button
: Select to enter custom label for button.
Soft Start
: Check box to allow slow increase in current at turn on.
Switch Type: Select switch behavior.
Normal, Momentary, Pulse (turn signal), Burst (high speed pulse, with
pause), SOS (distress pulse), Dim/PWM (Select 0-100% power for
dimming
lights or running motor at different speeds)
Max Current
: Select maximum fused amperage for circuit (0-30amps).
Limit Enabled:
Check box to limit circuit turn on by temperature settings
Temperature:
Select temperature to enable.
Hysteresis:
Differential temperature change required to activate.
(
Ex: With a 2º hysteresis and a 100º temperature setting the controller will allow
the actual temperature to go to 98º before turning off Fan and Pump and back to
100º to turn on again) allow the actual temperature to go to 98º before turning off Fan and
