Model Q 1074A - OPERATION MANUAL
7
3. CARE AND MAINTENANCE
3.1. CARING FOR YOUR MULTIMETER
Your Digital MultiMate is an example of superior design and craftsmanship. The following
suggestions will help you care for the multimeter so you can enjoy it for years.
1) Keep the multimeter dry. If it gets wet, wipe it dry immediately. Liquids can contain minerals
that can corrode electronic circuits.
2) Use and store the multimeter only in normal temperature environments. Temperature extremes
can shorten the life of electronic devices, damage batteries, and distort or melt plastic parts.
3) Handle the multimeter gently and carefully. Dropping it can damage the circuit boards and case
and can cause the multimeter to work improperly although the holster can provide enough
protection.
4) Keep the multimeter away from dust and dirt, which can cause premature wear of parts.
5) Wipe the multimeter with a damp cloth occasionally to keep it looking new. Do not use harsh
chemicals, cleaning solvents, or strong detergents to clean the multimeter.
6) Use only fresh batteries of the required size and type. Always remove old or weak batteries.
They can leak chemicals that destroy electronic circuits.
3.2. MAINTENANCE
9-Volt battery replacement or fuse replacement
WARNING
TO AVOID ELECTRIC SHOCK, REMOVE TEST LEADS BEFORE OPENING CASE AND BATTERY
DOOR.
1) Ensure the instrument is not connected to any external circuit. Set the selector switch to
“
OFF
“position and remove the test leads from the terminals.
2) Remove the screw on the battery case and lift the battery case. Remove the spent battery and
replace it with a battery of the same type.
Figure 2: Battery Replacement
3) Do not dispose the batteries with the household waste. Refer to your local area for the proper
disposal of used batteries.
4) Remove the screws on the bottom case and lift the case. Replace only with the same type and
rating of fuse F2 0.8A/600V FAST or F1 10A/600V FAST.
Battery: One standard 9
volt battery (NEDA 1604,
IEC 6F22 or equivalent)
Pull up the box case