- 3 -
ReServ4WP
Fig. 2 - ReServ4WP
P
N
LOW BATTERY
SHUTDOWN
Input
--- 24VDC +
15 16
1 2
24VAC
Outputs
(4A max.)
12VDC
Outputs
(1A max.)
Green Lead
12VDC Rechargeable Battery
(order separately)
12VDC Rechargeable Battery
(order separately)
5A
250V
Unswitched
115VAC
60Hz, 3.5A
power mains
Supervised
Note: Two (2) 12VDC rechargeable batteries
connected in series required.
CAUTION: Risk of explosion if battery is replaced by an
incorrect type. Dispose of used batteries according to the instructions.
Wall Mount Installation
1- Place unit at the desired location and secure with mounting screws
(not included) (Fig. 3, pg. 3).
Fig. 3
Pole Mounting Using Optional Pole Mount Kit PMK1
(not included)
:
This installation should be made by qualified service personnel. This product contains no serviceable parts. PMK1 is intended for use
with Altronix outdoor rated power supplies or accessories housed in WP1, WP2, WP3 and WP4 enclosures. Brackets are designed for
use with the Wormgear Quick Release Straps (two included).
1. Thread one (1) wormgear quick release strap through the slots on the back of a mounting bracket (Fig. 4, pg. 4).
2. Once the desired height of the top Pole Mount bracket is achieved, tighten the straps down by sliding open end of the strap through
the locking mechanism on the strap, then tighten the screw with flat head screwdriver or 5/16” hex socket driver (Fig. 4, pg. 4).
3. Attach the bottom bracket to the enclosure by inserting bolts through the flange of the enclosure and into the bracket, tightening
bolts with a 7/16” hex socket (Fig. 5, pg. 4).
4. Thread the second wormgear quick release strap through the slots on the back of the bottom mounting bracket (Fig. 7, pg. 4).
