1. Turn OFF the power of both the camera and receiver.
2. Mount the transmitter onto the camera’s hot shoe socket.
3. Mount the flash onto the receiver’s hot shoe socket.
4. If your flash or studio light do not have hot shoe entries, connect the studio light cable to
the flash or studio light to the ACC2 socket of the receiver.
5. Set the channel switches to the same position on both the transmitter and receiver.
(When using multiple flash units, verify that all receivers are set to the same channel.)
6. Switch the receiver mode to “Flash” mode.
7. Press the test button on the transmitter to confirm interaction.
8. If the transmitter and receiver status lights turn red while the flash trigger light turns on, all
settings are correct.
8
