KL3116 / KL3116T User Manual
38
(Continued from previous page.)
Setting
Function
TWO-POINT
CALIBRATION
Note:
This function is available on the KL3116T only.
Calibrates the touchscreen for use on ports with a connected
computer.
Note:
1. Before using two-point calibration, be sure to select a port
with a working computer attached, otherwise the
calibration will not be started.
2. Two-point calibration must be used when calibrating a
port for the first time.
3. If the calibration process is interrupted at any time
(accidentally switching ports, for example), press
[ESC]
to exit and start the calibration process again.
To perform a two-point calibration:
1. Use the touchpad or an externally connected USB mouse to
move the pointer near the upper left corner of the screen; then,
touch the pointer as instructed on-screen.
2. Use the touchpad or an externally connected USB mouse to
move the pointer near the lower right corner of the screen; then,
touch the pointer as instructed on-screen.
ONE-POINT
CALIBRATION
Note:
This function is available on the KL3116T only.
Use this function to quickly and easily recalibrate the touchscreen
with a single point.
Note:
1. Before using one-point calibration, be sure to select a
port with a working computer attached, otherwise the
calibration will not be started.
2. Two-point calibration must first have been performed on
the selected port before attempting a one-point
calibration. If the switch senses that a two-point
calibration has not been performed on the port, the one-
point calibration will not be started.
3. An even easier method of resynchronizing the on-screen
pointer can be found under
To perform a one-point calibration:
1. If necessary, use the touchpad or an externally connected USB
mouse to move the pointer so that it is visible on the screen.
2. Touch the pointer as instructed on-screen.
kl3116-3116t.book Page 38 Wednesday, June 1, 2011 1:28 PM
