14
Language:
English
Model
:
Netti 4U comfort|CED Version: November 2010
Language:
English
Model:
Netti 4U comfort|CED
Version:
November 2010
Language:
English
Model
:
Netti 4U comfort|CED Version: November 2010
netti rullestoler
Language:
English
Model:
Netti 4U comfort|CED
Version:
November 2010
T
ools needed are described under each chapter.
accessories described in chapter 5
is a presentation of options and will be
delivered with sepearate mounting descriptions.
6.2 Main wheel
To mount the main wheel remove the
quick release bolt from the hub bushing,
lead it through the centre of the main wheel
and into the hub bushing while pressing the
knob in center.
To check that the main wheel is
properly attached to the hub, remove
the finger from the central knob and
pull at the main wheel.
If the main wheel doesn’t lock, don’t
use the wheelchair but contact
your dealer.
Sand and sea water (salt used for
gritting in the winter) can damage the
bearings of the main wheels and front
castors. Clean the wheelchair
thoroughly after exposure
6.3 Front castors
To take off
• Press the release button under the front
fork.
To mount
• Lead the quick release axle into the
bearing house. Pull the fork slightly to
ensure that the fork is fully locked.
6.4. Seat height adjustment
The seat height at the rear depends on:
• Size of main wheel.
• Position of main wheel.
• Using 24” main wheels in the upper hole,
the seat height is 46.5 cm from the floor
to the seating plate.
• Using 24” main wheels in the next upper
position, the height will measure 50 cm to
the seating plate.
• Using 12” and 16” main wheels the seat
height is 46.5 cm from the floor to the
seating plate.
If it is required to change position of the
main wheels or to change to a different
size of main wheels, unfix the hub bushing
including washer and nut. remove the
hub bushing and mount it in the required
position.
