16
Language:
English
Model
:
Netti 4U comfort|CED Version: November 2010
Language:
English
Model:
Netti 4U comfort|CED
Version:
November 2010
Language:
English
Model
:
Netti 4U comfort|CED Version: November 2010
netti rullestoler
Language:
English
Model:
Netti 4U comfort|CED
Version:
November 2010
Ill. 6.5.3
• The back rest hinge has 4 holes (Ill.
6.5.4) The hole positions are in
accordance with the holes in the
plastic bracket. If the locking head of
the gas spring is mounted in the
inner hole of the plastic bracket, the
back rest hinge should also be
mounted in the inner hole etc.
Ill. 6.5.4.
6.6 Seat depth adjustment
at the rear.
• If the seat depth should be adjusted at
the rear, release the locking bolt from
the plastic bracket (Ill. 6.5.2).
• Find the required position for the locking
head in the plastic bracket, and remove
the plastic plug from this hole.
• Lock the back rest by pushing the locking
bolt through the plastic bracket and
the gas spring locking head.
• After changing the hole position in the
plastic bracket, the hole position in the
back rest hinge must be changed into the
parallel position.
Check that the hole in the back rest
hinge and the plastic bracket are
mounted in parallel position.
6 mm Allen-key
6.7 Seat depth adjustment
in front
It is possible to adjust the seat depth with
up to 10 cm in front. Do the following.
• Screw out the screws in the adjustment
piece (Ill. 6.7).
• Place the adjustment piece in the wanted
position
• Replace and tighten the screws
Ill. 6.7
6 mm Allen-key
If the user has spastic tendencies the
adjustment piece should not be pulled
out more than 5 cm.
