19
Language:
English
Model
:
Netti 4U comfort|CED Version: November 2010
netti rullestoler
Language:
English
Model:
Netti 4U comfort|CED
Version:
November 2010
Language:
English
Model
:
Netti 4U comfort|CED Version: November 2010
Language:
English
Model:
Netti 4U comfort|CED
Version:
November 2010
Squeeze hazard. When adjusting foot
supports in angle, do not put the fingers
in the adjusting mechanism
between the moving parts.
Adjusting the length of the foot support
• Untighten the screw (A) to make the
adjustment tube move
• Adjust the foot support in required
position and fix the screw properly.
Adjusting the angle of the footplate
• The foot plates can be adjusted in angle.
• Untighten the screw (B) and adjust the
foot plate to the required angle. Fix the
screw properly
5 mm Allen key.
Locking and releasing the foot plates
• The foot plates come with a locking bolt
which makes the plates stronger
• To lock the foot plates pull the plastic
lock on the right foot plate and place the
lock over the bolt on the left foot plate.
• To release the foot plate pull the plastic
lock and lift the right foot plate up.
While making the adjustment there
must be no load on the foot plates.
For outdoor use, there should be a
clearance of 4-5 cm between the
foot plate and the ground.
Removing the foot support:
• Pull the plastic lock on the foot plate
rearwards, so that the pin is released,
and the foot plate can be folded up.
• Raise the foot support a few degrees.
• Release the foot support by pulling it
slightly straight up.
• Swing the foot support outwards.
• Lift and remove the foot support. (ill. next
page).
