6
Model:
Netti
Grandis angle adjustable leg supports
Language:
English
Version:
2017-08
seat deptH adjustments
in tHe bacK:
by moving the back brackets
followed by adjusting the back
cylinder head. when the chair is
equipped with a main wheel larger
than 16” remove the main wheels
first. then remove the screws on
each side which are holding the
back hinge. pull the bracket on
each side back or push them for-
ward to desired position before the
screws are fixed again.
adjusting on netti 4u: remove the
bolt holding the recline cylinder
head and reposition it in the corre-
sponding number hole as the previ-
ously adjusted chair back bracket.
this will also have influence on
the chair back angle.
by choosing another hole you
can change the angle of the
back support which means that
the back angle or hip angle will
be more open or more closed.
seat deptH adjustments
in tHe Front:
are done by adjusting the extension
pieces where the leg supports are
mounted. the extension pieces are
adjusted by removing the screws
holding them and then pulling the
extension pieces out to desired
position.
the aim is to have the centre of
the users knee joint aligned with
the centre of the leg support knee
pivot centre - while the user at the
same time is having good back
support of his lower back - also
when the leg support angle is
changed.
always do seat depth adjustment
both in front and back to balance
the chair.
info@solidworks.com
info@solidworks.com
