18
language:
English
model:
Netti I Comfort
Version:
November 2010
Netti Rullestoler
When using the comfort seat plate it
is recommended to change seat
plate when changing seat depth. The
seat plate comes in depth: 40 cm, 43
cm & 46 cm.
By using the adjustment straps in the
rear you can gain a few cm on the
depth
Seat depth in the rear is adjusted as follows:
• Release the tilt gas strut by tilting the seat
all the way forward.
• Pull out the locking bolt for the back rest,
and place the backrest forward in the seat.
• Remove the screws holding the back rest
hinge, and set the back rest to the required
position. Do both sides at the same time.
• Place the screws back an fix them.
• Also remember to move the gas strut as
described earlier in this chapter.
When adjusting the seat depth at the
rear the screw in the backrest hinge
must be tightened with 14 Nm
6 mm allen key
13 mm open-end spanner
When changing seat depth, you also
change the tipping point of the
chair. This can be prevented by
changing the position of the main
wheel in the main wheel bracket.
(See chapter 6.6)
.
6.9 adjusting seat depth at
the front
It is possible to adjust the seat depth up
to 10 cm at the front. Do the following:
• Unfix the screw holding the pull out
piece for the foot support.
• Set the pull out piece to the required
position.
• Fix the screws.
6 mm allen key
By setting the pull out pieces to
different positions, it is possible to
compensate for a rotated pelvis or
different length of thighs.
6.10 anti tip
• Adjust the anti tip so that it doesn’t stick
outside the radius of the wheel.
• Pull the anti tip out / rearwards from
chassis.
• Turn it down 180°.
• Lock it in position by moving forwards
with spring tension.
