19
Language: English Model: Netti III HD Version: February 2013
When using the comfort seat plate it
is recommended to change seat plate
when changing seat depth. The seat
plate comes in depth: 40 cm, 43 cm &
46 cm.
By using the adjustment straps in the
rear you can gain a few cm on the
depth.
Seat depth in the rear is adjusted as follows:
• Release the tilt gas strut by tilting the seat
all the way forward.
• Pull out the locking bolt for the backrest,
and place the back rest forward in the seat.
• Remove the screws holding the back rest
hinge, and set the backrest to the required
position. Do both sides at the same time.
• Place the screws back and fix them.
• Also remember to move the gas strut as
described earlier in this chapter.
When adjusting the seat depth at the
rear the screw in the backrest hinge
must be tightened with 14 Nm
6 mm Allen key
13 mm open-end spanner
If the user requires other back rest
angles than what is standard, it is
possible to change the position of the
gas strut in three positions under the
chair in front.
When changing seat depth, you also
change the tipping point of the chair.
This can be prevented by changing the
position of the main wheel in the main
wheel bracket. (See chapter 6.6).
6.9 Adjusting seat depth at
the front
It is possible to adjust the seat depth up to
10 cm at the front. Do the following:
• Unfix the screw holding the pull out piece
for the foot support.
• Set the pull out piece to the required
position.
• Fix the screws, tighten them with 25 Nm
6 mm Allen key
By setting the pull out pieces to different
positions, it is possible to compensate
for a rotated pelvis or different length of
thighs.
6.10 Anti tip
• Adjust the anti tip so that it doesn’t stick
outside the radius of the wheel.
• Pull the anti tip out / rearwards from chassis.
• Turn it down 180°.
• Lock it in position by moving forwards with
spring tension.
