info@solidworks.com
info@solidworks.com
info@solidworks.com
Model:
NettI S
Language:
English
Version:
2020-08
18
My-Netti.com
• Tighten the screws.
• The recline gas spring must change
position so that the backrest angle equals
90° when the recline gas spring is in the
end position.
6 mm Allen key
13 mm open-end spanner
Attaching the gas spring under the chair
In order to achieve a 90° position of the
backrest the position of the gas spring
under the chair has to be changed when
the seat depth is adjusted. The hole where
the back hinge is mounted follows the
hole in the bracket where the cylinder is
mounted.
Back hinge position Cylinder position
If special user needs demands
a different angle than the recline
function allows, the position of the
gas spring can be adjusted.
When changing seat depth, you also
change the tipping point of the chair.
This can be prevented by changing
the position of the main wheel in the
main wheel bracket. (See chpt 6.6)
6.10 ADJUSTING THE SEAT
PLATE DEPTH AT THE REAR
The seat plate can be depth adjusted in
5 intervals (250 - 275 - 300 - 325 and
350 mm) without change of parts except
replacement of seat cushion to a depth
equal to new seat depth.
Adjustment is done as follows:
• Remove the cushions.
• Pull the armrest up to max height or
remove them.
• Access the screws sitting on the side of
the seat plate.
• Remove the screws on each side and
pull or push the back part of the seat
plate to desired seat plate depth.
• Insert the screws and fix.
• Replace all components.
