info@solidworks.com
info@solidworks.com
Model:
NettI S
Language:
English
Version:
2020-08
My-Netti.com
19
There is a seat plate depth scale
engraved on the seat plate.
6.11 ADJUSTING SEAT DEPTH AT
THE FRONT
It is possible to adjust the seat depth up to
100 mm at the front.
The aim is to have the
centre of the users knee joint aligned with
the centre of the leg support knee pivot point
- while the user at the same time has back
support of his lower back - also when the leg
support angle is changed.
• Unfix the screw holding the pull out piece for
the leg support.
• Set the pull out piece to the required
position. Tighten the screws with 25 Nm.
6 mm Allen key
By setting the pull out pieces to different
positions, it is possible to compensate for a
rotated pelvis or different thigh length.
By users with strong involuntarily
movements the extension pieces must not
be pulled out more than 50 mm.
THE SEAT DEPTH AT THE FRONT
For wheelchairs with seat width 350 and
400 mm, the seat depth can be extended
by adding 1 (+45 mm) or 2 ( 90 mm )
seat plate extenders, snapped on to the
extension pieces for the leg supports. Seat
plate extender to be ordered separately.
ABDUCTION BLOCK
The seat plate is prepared for mounting a
abduction block up to seat depth 350 mm.
Position the block bracket in the centre on
top of the seat plate. Push screws through
the 2 holes and fix with nuts from below.
6.12 ADJUSTING SEAT WIDTH
It is possible to adjust the seat width up to
90 mm - 45 mm on each side- by the use
of Seat width pads.
The aim is to position
the hip of the user in the centre of the seat
and give sideways hip support. As the user
grows the seat width pads are to be moved
outwards. When the most outward position
of the seat width pads are becoming too
narrow, the user need a bigger wheelchair.
The seat width pads are fixed to the
arm supports. They can be adjusted in 3
directions:
• Forward - backwards, in steps
• In the height, stepless
• In the width, stepless
The width pads can
slide inwards or
outwards by slightly
loosen these screws.
All adjustments by
4 mm Allen key
for M6 screws.
Tighten the screws
well after adjusting.
