info@solidworks.com
A
B
B
Model:
NettI S
Language:
English
Version:
2020-08
My-Netti.com
27
ADJUSTING THE DRUM BRAKE
If the brake does not brake properly:
adjust the wire on one or both sides,
adjust the foot screw 2-4 rounds out.
Then re-check the brakes.
If the wire is too loose:
Adjust the foot screw all the way in.
Tighten the wire by loosening the wire
clamp before pulling the wire further
through it. Tighten the wire clamp, and
adjust the foot screw out again
1 pc 10 mm open-end spanner.
To ensure the correct functions of
the wire, these must never be
taut.
6.22 CHANGE OF THE BACK
RECLINE CYLINDER
It may be required to change the cylinder for
adjustments to the user weight and power.
Fold the chair back forward by disconnecting
the chair back from the cylinder.
Open the nut
A
with a 17 mm open end
spanner and remove the cylinder.
Unscrew the cylinder head bracket
B
and fix
the bracket to the new cylinder.
Screw the new gas cylinder into the head
until it touches the cross bolt leaving no play.
Leave the nut
A
loose till the cylinder has cor-
rect depth.
If the cylinder sits too loose, you cannot re-
lease it with the operating handle; when it is
too tight, the operating handle will not lock
the cylinder.
Tighten the nut
A
close to the head with the
17 mm open end spanner and fix the gas cyl-
inder firmly.
Fold up the back and fix the cylinder to it.
Check the recline function.
