Devices (continued)
• Open and close Z-Wave garage door openers
• Control Z-Wave thermostats
**PLEASE SEE Z-WAVE USER GUIDE FOR ADDITIONAL INFORMATION**
Cameras
•
Cameras can be viewed directly from the Touchpad. Live view, clips, and event notifications
are supported. Doorbell live view will automatically be displayed when the doorbell button
is pressed. Internet access is required.
Scenes
• Create scenes from the Touchpad by clicking the “+ Add” button
• Enable/disable scenes with the toggle button
• Navigate to the edit scene page by selecting an item in the list
• Rename a scene by selecting the name label in the top bar
• Modify the scene by adding/removing triggers and actions
More - System
•
Status
• Troubles - shows all system troubles
• If a system trouble condition exists, the panel will sound trouble beeps
• To silence the trouble beeps for 24-hours:
• Go to system page
• Select the Silence button [upper right corner]
• Smoke Reset - When a smoke detector needs to be reset it will appear here. Tap and
confirm to reset.
Note:
This is supported for Napco panels. To reset smokes on all other panel types
navigate to Settings -> Panel -> Reset Sensors.
• Status Updates - shows all status updates
•
Touchpad
• Battery - shows battery level and charging information
• Network - shows network the Touchpad is connected to
• Access point MAC
• Wi-Fi signal strength - must not be less than 35
• Response Time
• Wi-Fi channel
• Touchpad Firmware
• Touchpad Hardware
• Touchpad Branding - shown if branding is applied
• Updater Firmware
• Serial Number
• FCC/IC information
• Uptime
