LEVIGATO DRIVES (LG SERIES)
|
LEVIGATO ANTRIEBE (SERIE LG)
|
COMMANDES LEVIGATO (SERIE LG)
25
ADjUSTMENT
6
‘
rc
’ is shown on the display, which means that the recording of remote controls
is expected
7
Press the selected control button 3 times on the remote
(the first control button)
8
The number which is to be assigned to the remote in the drive memory, will
automatically appear on the display (with the button
or
the
number can be changed)
9
Press the button
to confirm; after that a dot will appear on the display
10
In three seconds the automatic switch to the recording of the next remote con-
trol will take place. To exit the programming mode press the button
three times or wait for 15 seconds (until automatic exit the setup menu)
Deleting the remote control and defining of the record number of the remote
The
table 12
describes the settings, it is used when there is a remote control but the information
for the remote control number in the drive memory is not available.
1
Press and hold the button
for about 5 secs to enter the
programming mode
2
After the appearance of ‘
P1
’
inscription press the button
3
After the appearance of ‘
P2
’
inscription press the button
4
With the button
or
select the required setting:
‘
f7
’—defining the number of the remote control;
‘
f8
’—deleting the remote control
5
After the appearance of required setting (‘
f7
’ or ‘
f8
’) press the button
6
‘
rc
’ is shown on the display, which means that a signal from the remote control
is expected
7
Press the selected control button 3 times
8
The display will automatically show the number of the remote control in the
drive memory. If the remote control is not recorded, ‘
no
’ will be shown on the
display
9
To set ‘
f8
’ press the button
. A dot will disappear from the display, this
means that the remote control with the selected number is deleted from the
memory
Table 12
