ПРИВОДЫ TARGO (СЕРИЯ TR)
|
ПРИВОДИ TARGO (СЕРІЯ TR)
|
TARGO DRIVES (TR SERIES)
50
TESTING AND COMMISSIONING
S1
Final position switch (CLOSE), main
S2
Final position switch (CLOSE), auxiliary
S3
Final position switch (OPEN), main
S4
Final position switch (OPEN), auxiliary
S5 and S6
Auxiliary switches
A, B, C, D, E, F
Cams of the relevant switches (made in different colours)
G
Cam position adjusting wrench
Each cam has a locking screw
H
and a fine adjustment screw
I
. Using the locking screw
H
, the
cam is locked in the desired position. A more precise adjustment can be performed with the
fine adjustment screw
I
.
Adjustment of final position (CLOSED) (grey coloured cam)
:
• move the door to the fully closed position.
• Loosen the locking screw
H
on cam
A
and rotate the cam in the desired direction as close
to the follower of the switch
S1
as possible.
• Tighten the locking screw
H
.
• By turning the fine adjustment screw
I
, rotate cam
A
until switch
S1
trips (opens).
• Tripping of auxiliary switch
S2
when pressing cam
B
should be adjusted the same way.
The auxiliary switch
S2
must be adjusted to trip when the main switch
S1
trips.
Adjustment of final position (OPEN) (white coloured cams)
:
• move the door to the fully open position.
• Loosen the locking screw
H
on cam
C
and rotate the cam in the desired direction as close
to the follower of the switch
S3
as possible.
• Tighten the locking screw
H
.
• By turning the fine adjustment screw
I
, rotate cam
C
until switch
S3
trips (opens).
• Tripping of auxiliary switch
S4
when pressing cam
D
should be adjusted the same way.
The auxiliary switch
S4
must be adjusted to trip when the main switch
S3
trips.
After adjustment of the final positions, the movement of the door leaf must be checked using
the control unit. Ensure that the door leaf stops at the desired final positions, and that the control
unit indication when the final position switches are actuated is correct. If necessary, adjust the
position of the final position cams.
7.
TESTING AND COMMISSIONING
After product mounting, connecting and adjustment, several steps must be taken to verify
proper operation:
• make sure that the full scope of the instructions in section «1. General warnings and safety
rules’ and other requirements of the manual are complied with.
• Ensure stable and secure mounting of the drive relevant to the loads. All previously
removed drive covers must be replaced.
Table 3
