Supervisor 2000 Installation Instructions
PUD1601R6-1
For Assistance: support@alvaradomfg.com +1 (909) 591-8431
Page 3
The following symbols are used throughout the manual to highlight important information and
potential risks when installing, servicing or using the turnstiles covered in this manual.
This symbol is used in this manual to warn installers and operators of
potential harm. Please read these instructions very carefully.
This symbol is used in this manual to designate potential conditions that
may pose a risk to pedestrians, personnel, property and equipment. Please
read these instructions very carefully.
NOTE
This symbol is used in this manual to designate useful information for the
installer and operator. Please read these instructions.
For questions, please contact Alvarado at (909) 591-8431, Monday – Friday
7:00am to 4:30pm PST. Please read this manual completely before
installing or operating the purchased product.
Safety Icons
A minimum of two people
is required to complete
the installation of this
product.
The Supervisor 2000 may present a risk to persons and property if it is not installed and/or operated
correctly. Therefore, this manual must be read in its entirety and all safety and operations
information must be adhered to. Note the following precautions:
•
For indoor use only.
•
Use only skilled individuals to install and service the turnstile.
•
DO NOT operate the turnstile if it has been damaged in any manner. If damaged, have the unit repaired or adjusted by a
skilled service person before use.
•
DO NOT modify or alter the turnstile.
•
Have skilled individuals maintain the turnstile according to a proper maintenance schedule.
•
In access control applications, train all personnel that will be using the turnstile in the proper method of operation. In
addition, properly train new users as they are added to the system.
•
DO NOT use non-Alvarado parts to repair a damaged turnstile.
•
Closely follow the handling instructions for moving or lifting the turnstile during installation.
•
Power off the turnstile before connecting or disconnecting any communication or power wiring to the turnstile.
•
The turnstile shall be disconnected from its power source during service and when replacing parts. The turnstile shall be
disconnected from its power source before connecting or disconnecting any communication or other activation/feedback
control wires. If it is not possible that the technician can check from any point to which he has access that the main power
is removed, a disconnection with a locking system in the isolated position shall be provided.
Safety Precautions
CAUTION
WARNING
WARNING
